Tripp Lite UT750UL - Manual

Inverter DC Volt: 12
Wire Gauge
Watts 6 4 2 0 00 (2/0)
500 15 ft 25 ft 39 ft 62 ft 79 ft
700 11 ft 18 ft 28 ft 44 ft 56 ft
1000 N/R 12 ft 20 ft 31 ft 39 ft
2000 N/R N/R N/R 16 ft 20 ft
† N/R = Not Recommended. NOTE: Acceptable power is directly related to
cable length (i.e. - the shorter the cable, the better the performance)
Note on Labeling Two symbols are used on the RV labels.
V~ : AC Voltage V : DC Voltage
Minimum Recommended Cable Sizing Chart †
Use in conjunction with DC wiring connection instructions in the Battery Connection section.
Specifications
MODEL NUMBER: UT750UL UT1250UL UT2012UL
Series Number: AGAP5088 AGAP5217 AGAP5290
Agency Approvals: cULus 458 cULus 458 cULus 458
AC Input Connection (for optional charging): Input Cord Input Cord Input Cord
AC Output Connection: Two GFCI Outlets Two GFCI Outlets Two GFCI Outlets
INVERTER
Continuous Power (@ 20 C): 750 1250 2000
OverPower™ Peak Surge Power:* 1125 1875 3000
Double Boost™ Peak Surge Power:* 1500 2500 4000
Maximum Output AC Current (Continuous): 6.3 A 10.4 A 16.7 A
UL-Recognized DC Fuse Required: One 80 A One 200 A Two 200 A
DC Input Current @ Nominal V DC Full Load: 72 A 127 A 190 A
DC Input Volts (Nominal): 12 VDC 12 VDC 12 VDC
DC Input Voltage Range: 10-15 VDC 10-15 VDC 10-15 VDC
Output Volts (Nominal): 120 VAC, ± 5% 120 VAC, ± 5% 120 VAC, ± 5%
Output Frequency (Nominal): 60 Hz, ± 0.5 % 60 Hz, ± 0.5 % 60 Hz, ± 0.5%
Efficiency: 88% to 94%, depending on 88% to 94%, depending on 88% to 94%, depending on
load and temperature load and temperature load and temperature
BATTERY CHARGER
Charging Capacity DC: Selectable 45 A** / 11 A Selectable 40 A** / 10 A Selectable 60 A** / 15 A
Input Current AC: 9.3 A 8.2 A 12 A
Acceptance Volts VDC: Selectable 14.4V** / 14.2 V Wet** / Gel Selectable 14.4V** / 14.2 V Wet** / Gel Selectable 14.4 V** /14.2 V Wet** / Gel
Float Volts DC (Wet/Gel): 13.3 V (13.6 V) 13.3 V (13.6 V) 13.3 V (13.6 V)
Input Volts (Nominal): 120 VAC 120 VAC 120 VAC
* OverPower duration (up to 1 hour). DoubleBoost duration (up to 10 seconds). Actual duration depends on battery age, battery charge level and ambient temperature. **Factory setting. The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice. This
product designed and engineered in the USA.
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number
can be found on the product nameplate label, along with all required approval markings and information. When requesting compliance information for this
product, always refer to the series number. The series number should not be confused with the marking name or model number of the product.
C US
UL
1111 W. 35th Street Chicago, IL 60609 • (773) 869-1234 • www.tripplite.com
200502085 93-2433
200502085.qxd 3/3/2005 11:48 AM Page 1