beautypg.com

Before operating this recorder – Toshiba RD-XS54SU User Manual

Page 20

background image

20

Is your recorder ready?

• Refer to “INSTALLATION GUIDE” manual and finish

the necessary preparations.

• Turn on the connected equipment such as a TV or

audio system and select the input from the recorder.

Turning the power on

(This owner’s manual instructions are based on
the premise that all proper connections have been
completed and the TV is turned on.)

Press ON/STANDBY on the front panel of the
recorder or on the remote control.

When the power turns on, the ON/STANDBY indicator
changes from red (standby mode) to green (operation).
After a few seconds, a start-up screen appears.
The following icon appears at the top right corner of
the screen.

When this icon disappears, the recorder is ready to
operate. If the disc drive contains a disc, it takes a
little longer to start up.

Viewing TV channels through this recorder

After turning the power on, the recorder will output TV
channel signals to the connected TV (also in the stop
mode).
You can select a desired channel by pressing the CH/
Page or the number buttons.

Loading a disc

Check disc compatibility beforehand (

page 6, 7)

and use a proper playable disc.

Caution
• Keep your fingers well clear of the disc tray. Neglecting this

may cause serious personal injury. Keep a close watch on
children.

• Do not use a cracked, deformed, or repaired disc.

1 Open the disc tray.

Press

on the front panel or the OPEN/CLOSE

button on the remote control.

2 Insert a disc.

Disc without a cartridge

Insert with the playback side down.

There are two kinds of disc size. Place a disc to fit
the dish. If a disc is out of the dish, it may result in
damage to the disc or malfunction.

Place a disc in the
inside hollow.

Introduction

Before operating this recorder

Loading

e.g.

ON/STANDBY button

CH/Page buttons

ON/STANDBY button/
ON/STANDBY indicator

OPEN/CLOSE button

button

RD-XS54SU/SC_Ope_E_p020-030

05.7.10, 2:58 PM

20