Tunturi T20 - Manual (Page 3)

G B
3
O W N E R ' S M A N U A L • T 2 0
Lift up the upright, then place the screws (A) and
washers (B, C) inside holes at the bottom of the
upright. Use the screwdriver (F) to tighten them well.
Put the console to the correct position. Use the allen
key (E) to tighten the screws (A) and washers (C)
inside holes at the top of the upright.
Attach side cap (H) with the screws (D) at the bottom
of the upright, and tighten them well.
ASSEMBLY
As for the assembly of the device, we recommend two
grown-up persons. Use the packing material to cover
the floor on the assembly site.
Before assembling the device, insure all parts are
present:
1.
Frame
2. Power cord
3. Assembly kit (contents are marked with an * in the
spare part list): keep the assembly tools, as you may
need them e.g. for adjusting the equipment
In case of problems contact your Tunturi dealer. The
directions left, right, front and back are defined as
seen from the exercising position. To avoid injury,
you must fold up the deck prior to lifting the treadmill
out of the box.
Take the treadmill out of the box, and lay the
treadmill flat on floor as shown in Figure 1. Locate
the hardware bag and parts that are listed in the chart
below.
A
B
C
D
E
F
G H
Part# Description Q´TY
A Screw M8x20L 6
B Washer Ø8xØ18 2
C Washer Ø10xØ25 4
D Screw M4x6L 6
E Allen Key 1
F Screwdriver 1
G Safety Key 1
H Side Cap 2