Programming your remote control, Programming volume and mute keys – Technicolor - Thomson 42 WM 03 L User Manual

Page 30

30 Plasma Monitor

Miscellaneous

Programming your remote control

To control other devices

You can program your remote control for it to control other devices. Before following the adjustment procedure below, look for the 3-
digit code number(s) corresponding to the make of the device(s) to be controlled in the list of codes enclosed separately, then insert
them in the table below.

Apparatus

Codes

Amplifier

VCR

Programming Volume

and Mute

keys

Your remote control has been factory-set to control the

Volume +/-

and

Mute

(

) functions on the THOMSON DPL 2000 amplifier.

If you wish to control the

Volume +/-

and

Mute

(

) functions on your set, you

must change the factory-settings as follows:

1. Slide the

key to the

plasma

position.

2. While maintaining the

key pressed, key in the code "001".

3. Release the

menu

button.

Volume +/-

and

Mute

(

) keys are now configured to control the set. To control the amplifier, place the key on the

hi-fi

position.

To return to factory-settings, repeat the above procedure, keying in "000".

1. Position the switch on the device that you want to control.

2. Keep the

key down and enter the 3-digit code.

3. Release the

key.

• Try to control the device by turning it off, then on with the

key

(the above key being on the corresponding position).

• If this does not work, repeat the process from step 2 with another 3-digit code.

• Some devices cannot be controlled by the universal remote control supplied.

• Test the functions that you can control by using this remote control.

• According to the devices and the date they were put on the market, all the functions may not be available.

•

If you have programmed you remote control to control other makes than Thomson, it may be necessary to

reprogram it when you change the batteries.

Satellite receiver

DVD or LD unit

Amplifier

Monitor

Code

000

001