Teac CR-H227I - Manual (Page 33)

33
Press the TUNING button to tune in a station.
In the Auto tune mode, the unit starts searching for
a station. When a station is tuned in, the tuning
process will stop automatically.
Repeat this step until the station you want to listen
to is found.
< If you want to stop the tuning process, press the
TUNING button.
In the Manual tune mode, the frequency changes
by a fixed step. Repeatedly press (or hold down) the
TUNING button until the station you want to listen
to is found.
< The “TUNED” indicator lights when a station is
correctly tuned in.
If the reception is poor
Rotate or relocate the antenna to find the best
position for reception.
4
FM MODE Button
Pressing this button alternates between Stereo
mode and Mono mode.
Stereo
FM stereo broadcasts are received in stereo and the
“STEREO” indicator lights in the display.
< If the sound is distorted and the “STEREO”
indicator flashes, the signal is not strong enough
for good stereo reception. In this case, change to
Mono mode.
Mono
To compensate for weak FM stereo reception,
select this mode. Reception will now be forced to
monaural, reducing unwanted noise.
Listening to the Radio
Press the TUNER button of the remote control
unit (or repeatedly press the SOURCE button)
to select “TUNER”.
< You can also use the BAND button or the remote
control unit to select “TUNER”.
Select AM or FM by pressing the BAND button.
Press the TUNING MODE button to select the
tuning mode.
Each time the TUNING MODE button is pressed, the
tuning mode changes as follows:
Manual tune, Auto tune, Preset tune
Select “Manual tune” or “Auto tune”.
3
2
1
1
2 3
FM MODE