Teac CR-H227I - Manual (Page 31)

31
To check the programmed order
In the stop mode, press the PROGRAM button
repeatedly. The track number and program number
will be shown on the display.
To add a track to the program
In the stop mode, press the PROGRAM button
repeatedly until the program number you want to
insert a track appears on the display. If you want to
add a track to the end of the program, press the
PROGRAM button repeatedly until “P-End” briefly
appears on the display.
Then select a track number using the numeric
buttons. The track is added to the program.
To delete a track from the program
In the stop mode, press the PROGRAM button
repeatedly until the program number to be deleted
appears on the display, then press the CLEAR
button. The selected track/file is deleted from the
program.
To clear the program
1. In the stop mode, press the PROGRAM button.
2. Hold down the CLEAR button for more than 4
seconds.
< If one of the following buttons is pressed, the
programmed contents will also be cleared:
SOURCE (AUX, TUNER, TAPE, iPod),
OPEN/CLOSE (L), BAND
< If the unit is disconnected from the power supply,
the programmed contents will be cleared.