Teac CR-H227I - Manual (Page 29)

29
Each time the REPEAT 1/ALL button is pressed, the
mode is changed as follows:
When a CD is loaded:
When an MP3/WMA disc is loaded.
< If one of the following buttons is pressed, repeat
mode will be canceled:
STOP, SOURCE (AUX, TUNER, TAPE, iPod) ,
BAND, OPEN/CLOSE, STANDBY/ON
Repeat 1 RPT Folder Repeat All
Repeat 1 Repeat All
Play (off)
Play (off)
Repeat one track (Repeat 1)
The track being played will be played repeatedly. If
you press the SKIP button (.or/) and select
another track, the track you selected will be played
repeatedly.
It is also possible to select a track to be repeated in
the stop mode. Press the REPEAT 1/ALL button and
select a track using the numeric buttons.
Repeat all the tracks in the folder (RPT Folder)
(MP3/WMA only)
All the tracks in the folder will be played
repeatedly.
< This mode is not available in the stop mode.
< When the disc has no folder, this mode will be
skipped.
Repeat Playback (CD/MP3/WMA)
This function allows repeat playback of any desired
portion of the disc.
1. Designate the point at which repeat playback
should start by pressing the A-B button.
“Repeat A-” lights up and “B” blinks.
2. When the point at which repeat playback
should end is reached, press the A-B button
again.
“Repeat A-B” lights up.
The designated point with A-B button will be
played back repeatedly.
< To return to normal play, press A-B button until
“Repeat A-B” disappears from the display.
< There must be more than 3 seconds between A
and B.
A-B Repeat Playback
Repeat Playback Repeat all the tracks (Repeat All)
All the tracks will be played repeatedly.
During programmed playback, programmed tracks
will be played repeatedly.