Toshiba SD-370EKE - Manual (Page 25)

25
• DO NOT connect the COAXIAL DIGITAL AUDIO OUT
jack of the DVD video player to the AC-3 RF input of
a Dolby Digital Receiver. This input on your A/V Receiver
is reserved for Laserdisc use only and is incompatible with
the COAXIAL DIGITAL AUDIO OUT jack of the DVD
video player.
• Connect the COAXIAL DIGITAL AUDIO OUT jack of
the DVD video player to the “DIGITAL (COAXIAL)”
input of a Receiver or Processor.
• Refer to the owner’s manual of the connected
equipment as well.
• When you connect the DVD video player to other
equipment, be sure to turn off the power and unplug all of
the equipment from the wall outlet before making any
connections.
• The output sound of the DVD video player has a
wide dynamic range. Be sure to adjust the receiver’s
volume to a moderate listening level. Otherwise, the
speakers may be damaged by a sudden high volume
sound.
• Turn off the amplifier before you connect or disconnect
the DVD video player’s power cord. If you leave the
amplifier power on, the speakers may be damaged.
• For connection to your TV, see “Connecting to a TV”
(see pages 21~23).
• This section uses the following reference marks.
: Front speaker
: Rear speaker
: Sub woofer
: Center speaker
: Signal flow
Connecting to Optional Equipment
You can enjoy high quality dynamic sounds by connecting the DVD video player to optional audio equipment.
• When you are connecting (via the COAXIAL
DIGITAL AUDIO OUT jack) an AV decoder that does
not have Dolby Digital, Digital Theater Systems
(DTS) or MPEG2 decoding function, be sure to set
“Digital Output” to “PCM” from the on-screen displays
see page 32. Otherwise, high volume sound may
damage your hearing as well as the speakers.
• When playing DTS-encoded discs (DVD Video discs
and audio CDs), excessive noise may be output
from the analogue audio output jacks. To avoid
possible damage to the audio system, you should
take proper precautions when the analogue audio
output jacks of the DVD video player are connected
to an amplification system. To enjoy DTS Digital
Surround™ playback, an external 5.1 channel DTS
Digital Surround™ decoder system must be
connected to the COAXIAL DIGITAL AUDIO OUT jack
of the DVD video player.
Connections