Toastmaster TW240 User Manual
Page 10
3-2
SECTION 3 - OPERATION
D. CLEARING JAMS
WARNING
NEVER INSERT YOUR HANDS INTO THE
TOASTING CHAMBER TO CLEAR A JAM.
SERIOUS INJURY MAY RESULT.
CAUTION
NEVER use a plastic object to clear a jam. If the toaster
is not completely cool, damage to the toaster may result.
CAUTION
When clearing a jam, use care to avoid damaging the
heating elements.
1. Switch the ON/OFF/STANDBY knob to the OFF
position.
2. Disconnect electrical power to the toaster at the
circuit breaker/fused disconnect.
3. Allow the toaster to cool.
4. Carefully clear the jam using a long object as a probe.
This object should preferably be made of wood, which
is less likely to damage the heating elements.
E. DAILY CLEANING
WARNING
WHEN CLEANING THE TOASTER, NEVER
APPLY ENOUGH LIQUID TO STAND IN
PLACE ON THE UNIT. DO NOT SPRAY,
RINSE, OR SUBMERGE THE TOASTER.
EXCESSIVE MOISTURE IN THE UNIT WILL
CAUSE A SEVERE ELECTRICAL HAZARD
AND MAY OTHERWISE DAMAGE THE
TOASTER.
CAUTION
DO NOT clean your toaster using abrasive cleaners or
pads. Both will scratch and dull the finish.
1. With the conveyor running, use a brush to clean any
crumbs off the conveyor into the slide-out crumb tray.
2. Switch the ON/OFF/STANDBY knob to the OFF
position.
3. Disconnect electrical power to the toaster at the
circuit breaker/fused disconnect.
4. Allow the toaster is cool.
WARNING
DO NOT TOUCH HOT SURFACES ON THE
TOASTER, OR REACH INTO THE TOASTING
CHAMBER, UNTIL THE UNIT HAS COOLED
THOROUGHLY.
5. Wipe the exterior of the toaster with a sponge or cloth
soaked in hot or warm detergent water. Wipe with a
clean, damp cloth to remove the excess detergent,
and then wipe again to dry the toaster.
6. Remove both the slide-out crumb tray and the return
crumb tray from the toaster, and empty them. Wash
the crumb trays in warm detergent water, and rinse
them.
CAUTION
Never remove the slide-out crumb tray while the conveyor
is moving.
7. Remove the entry and exit racks from the toaster.
Wash the racks in warm detergent water, and rinse
them.
8. Towel the trays and racks dry. Reassemble all parts
onto the toaster.