Technics SC-DV290 - Manual (Page 37)

37
RQT6894
Recording operations
x
A Recording the radio
Preparation: Do the preparatory steps ( ➡ page 35).
1
Tune to the required station.
( ➡ page 27, 28)
2
Press [ q REC PAUSE].
The deck goes into the recording standby mode and the play indicator
“
” or “ ” starts flashing.
3
Press [ ] (reverse side) or [ ] (forward side) to start
recording.
To stop recording
Press [ w ].
To temporarily stop recording
Press [ q REC PAUSE].
The deck goes into recording standby mode.
To resume recording press [
] or [ ] with the flashing indicator.
x
B Tape-to-tape recording
Preparation:
p Do preparatory steps 1 and 3 ( ➡ page 35).
p Insert the tape to be recorded in deck 1.
1
Set the tape direction on both decks.
Press [DECK 1/2] to select “DECK 2”.
First press [ ] or [ ], and then [ w ].
Repeat steps and for deck 1.
2
Press [TAPE EDIT] to start recording.
The indicator “ ” or “ ” shows deck 2 direction.
If either deck 1 or deck 2 stops, the other deck also stops.
To stop recording
Press [ w ].
Both decks stop.
To enjoy another source while recording
Start playing the other source.
You can change the volume level and tone quality without affecting the re-
cording.
Note
The recording level and the noise reduction effect of the original (playback)
tape will be recorded on the new tape.
1
2
B
A
2
3
´ REC
PAUSE
DECK 1/2
º
º
2 1
2 3
º
MHz
NR ë
2
NR ë
2
TAPE EDIT
REC
REC
TUNED