Tandberg Data FS-1610 - Manual (Page 22)

Tandberg Data Setting Up
_____________________________________________________________
2-10 Tandberg Viking FS-1600 Series NAS Hardware User Manual
2. Connect the PS/2 keyboard and mouse into the PS/2 keyboard and
mouse ports on the rear panel of FS-1600 Series NAS appliance.
Notes
If USB keyboard and mouse are used, they can be connected on the rear panel of
the FS-1600 Series NAS appliance.
3. Connect the power cord to the power connector located on the rear
panel of the FS-1600 Series NAS appliance and connect the other
end of the power cable to a power outlet.
2.5. Turning ON the Viking FS-1600 Series NAS
Appliance
After making sure that you have set up the FS-1600 Series NAS appliance
correctly and connected all the required cables, you can turn on you can turn
on the appliance.
1. Press the power button. The FS-1600 Series NAS appliance starts
and displays a welcome message. After that, a series of power-on
self test (POST) messages appear. The POST messages indicate
whether the appliance is running correctly.
2. If the appliance does not turn on or boot after pressing the power
button, go to the next section for the possible cause of the boot
failure.
3. Aside from the POST messages, you can determine if the NAS is in
good condition by checking if the following occurred:
o
Power indicator on the front panel is green.
o
Num Lock, Caps Lock, and Scroll Lock LEDs on the
keyboard are on.
Notes
The default login and password for Windows Storage Server 2003 is
“Administrator” and “1234”.
2.6. Troubleshooting
If the FS-1600 Series NAS appliance does not boot after you turn it on,
check the following factors that might have caused the boot failure:
• The external power cable may be loosely connected. Check the
power cable connection from the power source to the power cable
connector on the rear panel. Make sure that the cable is correctly
connected to the power source and to the power cable connector.