Tandberg Data FS-1610 - Manual (Page 15)

Tandberg Data Setting Up
_____________________________________________________________
2-3 Tandberg Viking FS-1600 Series NAS Hardware User Manual
2.1.9. Sufficient Ventilation
The vents on the front panel and the fan openings on the rear panel provide
ventilation for the FS-1600 Series NAS appliance. Make sure that these
openings are not blocked and that adequate ventilation is provided where
the unit is installed.
2.2. Accessing the HDD Tray & Installing Hard
Drives
To install HDD to the FS-1600 Series NAS appliance, remove the drive tray
from the chassis in order to mount any Serial-ATA I or II HDD.
1. Press the release tab to release the drive tray from its locking
position.
2. Pull the drive tray out from the chassis by:
a. Pressing the tray handle release button.
b. Grab the tray handle and pull out the drive tray from the
chassis.
3. Remove the 2 screws at each side of the dummy tray and take out
the dummy tray as shown below:
Drive Tray
Dummy Drive
Release Button