Toshiba DKT3001/2001 - Manual (Page 34)

Advanced Operation
Call Forward
22
Strata CTX DKT3001/2001 Digital Single Line Telephone 01/02
Some Call Forward features require a Pass Code entry. Use the following procedure to
change your Pass Code.
➤
To change your Pass Code
➤
Dial + Ext. No. + old Pass Code (1~15 digits) + + new Pass Code (1~15
digits) + .
➤
To use the Call Forward button sequence
➤
Use the procedure for dialing from your telephone, then use the Button Sequence
(see
Table 2 ) for the desired feature.
Some features require additional input, such as:
• Destination – If the destination is an outside number, press ÆÃ after entering the
destination. The CTX accepts destination numbers of up to 32 digits.
• Timer – This is a two digit entry representing how long (8 to 160 seconds) your
telephone should ring before forwarding the call. If you enter one digit, you
must press
ÆÃ after entering the single digit.
• Pass Code – A four-digit code established by system programming to prevent
unauthorized changes. The code applies to the station to be forwarded; not to
the station entering the code.
Note Also, in the following table, (Tone) means that a confirmation tone will play at
that point in the sequence.
Table 2 Call Forward Procedure
Feature Button Sequence
Call Forward Any Call (Internal and Incoming Line)
All Call Æ% (Tone) + Destination No. (Tone)
Busy Æ%! (Tone) + Dest. No. (Tone)
No Answer Æ%" (Tone) + Dest. No. (Tone) + Timer + Æ
Busy No Answer Æ%# + Dest. No. + Timer + Æ
Cancel Æ%$ (Tone)