2 wireless connection troubleshooting, Not able to connect wireless clients, No wireless connectivity – Technicolor - Thomson 585 v7 User Manual
Page 61: Poor wireless connectivity or range, Change the wireless channel, Wireless connection troubleshooting
E-DOC-CTC-20080118-0003 v1.0
55
7
Troubleshooting
7.2.2
Wireless Connection Troubleshooting
Not Able to Connect Wireless Clients
Check the following:
If registration is enabled, you must press the 'Association' button to register the wireless client or search
for wireless devices via the embedded web pages.
Make sure the Thomson Gateway Association Control List is not locked. You can check this on the web
pages. On the Wireless Access Point settings, make sure New stations are not allowed is NOT selected.
No Wireless Connectivity
Make sure that:
Both the wireless client adapter and the Thomson Gateway are allowed to connect through wireless
channels as defined for local regulatory domain.
The wireless client is configured for the correct wireless settings (SSID, security settings).
Check the signal strength, indicated by the wireless client manager. If the signal is low, try repositioning
the Thomson Gateway or directing the Thomson Gateway’s antenna(s) for optimal performance.
Make sure that the wireless client adapter is enabled (message like “radio on”).
Poor Wireless Connectivity or Range
Try the following:
.
Make sure both the wireless client adapter and the Thomson Gateway are allowed to connect through
wireless channels as defined for local regulatory domain.
Check the location of the Thomson Gateway in the building.
Check the signal strength, indicated by the wireless client manager. If the signal is low, try to place the
Thomson Gateway or to direct the Thomson Gateway’s antenna(s) for optimal performance.
Change the wireless channel
Proceed as follows:
1
Browse to the
.
2
On the left menu, click Home Network.
3
Under Wireless, click your access point.
4
The Wireless Access Point page appears.
5
In the
, click Configure.
6
Under Configuration, select the channel of your choice in the Channel Selection list.
7
Click Apply.
Your access point will be listed in the following format: “WLAN: