Technicolor - Thomson 585 v7 - Manual (Page 42)

E-DOC-CTC-20080118-0003 v1.0 36
5 Wireless Security
5.1 Encryption
Introduction
By using encryption, communication between the wireless clients and your Thomson Gateway is protected
by a passphrase. Only clients which use the correct network name (SSID) and passphrase can connect to your
network.
Encryption methods
During the years a number of encryption types have been developed. The list below gives you an overview of
the supported encryption types ordered by security level, you will find the highest level of security at the top
of the list:
WPA-PSK Encryption:
The wireless data is being encrypted with a user-defined key. Wireless clients must be configured with
this key before they can connect to the Thomson Gateway.
WEP Encryption:
The first encryption type used for wireless connections. Like WPA-PSK it uses a user-defined key, but WEP
has been proven to have some security issues. We strongly recommend you to use WPA-PSK instead.
Configuring the wireless encryption
Proceed as follows:
1 Open the Thomson Gateway Web Interface .
2 On the left menu, click Home Network.
3 Under Wireless, click your access point.
4 The Wireless Access Point page appears.
5 In the Navigation Bar , click Configure.
6 Under Security, you can change the Encryption. If you want to use:
WEP Encryption, continue with “5.1.1 Configuring WEP Encryption” on page 37 .
WPA-PSK Encryption, continue with “5.1.2 Configuring WPA-PSK Encryption” on page 38 .
Your access point will be listed in the following format: “WLAN: (Speed>)”. For example, WLAN: Thomson83C7C7 (54Mbps).