Topcom ORBIT - Manual (Page 34)

34
Troubleshooting
13 Troubleshooting
14 Technical dataTechnical characteristics
Symptom Possible cause Solution
No display Batteries uncharged Check the position of the batteries
Recharge the batteries
Handset turned OFF Turn ON the handset
No tone Telephone cord badly
connected Check the telephone cord
connection
The line is occupied by
another handset Wait until the other handset hangs
up
The icon flashes Handset out of range Bring the handset closer to the base
The base has no power supply Check the mains connection to the
base
The handset is not registered
on the base Register the handset on the base
Base or handset do not ring The ringing volume is off or
low
Adjust the ringing volume
Not possible to transfer a
call on PABX The Flash Time is too short or
too long Change the Flash Time
Telephone does not react
to pressing the keys Manipulation error Remove the batteries and put them
back in place
Standard DECT(Digital Enhanced Cordless Telecommunications)
GAP (Generic Access Profile)
Frequency range 1880 MHz to 1900 MHz
Number of channels 120 duplex channels
Modulation GFSK
Speech coding 32 kbit/s
Emission power 10 mW ( average power per channel )
Range 300m in open space /50m maximum in-house
Number of handsets Up to 5
Base power supply 230V / 50 Hz / 6,5V DC 300mA
Handset Batteries: 2 rechargeable batteries AAA, NiMh 1,2V, 750mA
Handset autonomy 110 hours in standby
Handset talk time 11 hours
Normal conditions of use +5 °C to +45 °C
Dialling mode Pulse / Tone
Flash time 100 or 250 ms
Measurements base ca. 112mm x 112mm x 64mm (L x B x H)
Measurements handset ca. 34mm x 52,5mm x 154mm (L x B x H)
Weight base with adaptor
Weight base without adaptor ca. 319g
ca. 135g
Weight handset with batteries ca. 124g