Toshiba 26DF56 - Manual (Page 35)

35
Appendix
Using the
TV’
s
Features
Setting up
your TV
Using the
Remote Control
Connecting
your TV
W
elcome to T
oshiba
Important
Safeguards
Checking the digital signal strength
You can check the strength of the digital signal by viewing the digital
signal meter.
To view the digital signal meter:
1. Press MENU, then press or
to display the SETUP menu.
2. Press ▲ or ▼ to highlight SIGNAL
METER.
3. Press or to check the digital
signal strength.
4. Press EXIT to return to the normal screen.
Menu/Enter
Resetting your audio adjustments
The RESET function returns your audio adjustments to the following
factory settings:
MTS ................. STR
Bass ................. center (25)
Treble ............... center (25)
Balance ............ center (0)
To reset your audio adjustments:
1. Press MENU, then press or to
display the AUDIO menu.
2. Press ▲ or ▼ to highlight RESET,
and then press .
Digital output ..................... PCM
Stable sound ..................... OFF
Surround ........................... OFF
: S E L E C T : A D J U S T
A U D I O
S TA B L E S O U N D
S U R R O U N D
R E S E T O F F
O F F
Using the surround sound feature
The surround sound feature expands the audio listening field wider and
deeper to create exceptional sound quality from the TV’s speakers.
The feature uses stereo signals from a TV broadcast or video input.
To turn on the surround sound feature:
1. Select the STEREO mode, if available (see “Selecting stereo/SAP
broadcasts” on page 33.)
2. Press MENU, then press or to
display the AUDIO menu.
3. Press ▲ or ▼ to highlight
SURROUND.
4. Press or to highlight ON.
To turn off the surround sound feature:
Highlight OFF in step 4 above.
In general, you can leave your TV in surround mode because it will
automatically output the type of sound being broadcast (surround
stereo or monaural).
S I G N A L M E T E R
C H A N N E L ( D I G I TA L ) 1 - 0 0 1
8 0
A U D I O
S T A B L E S O U N D
S U R R O U N D
R E S E T
: S E L E C T : A D J U S T
O F F
O N
/ O F F
Exit
Note:
• The SIGNAL METER feature is not
available for analog channels.
• After approximately 4 minutes, the SIGNAL
METER screen will return to normal TV-
operation automatically.
• When you select a vacant channel, the
signal meter may react.
Using the
TV’
s
Features
3Y90121A(E)_P32-Back 4/6/06, 3:14 PM 35