Tripp Lite OmniSmart RMX 500 VA - Manual (Page 4)

4
Connection
4
Hardwire the UPS’s input to utility
power and its output to its load.
Consult a qualified electrician and follow all
applicable electrical codes and requirements.
Your UPS is designed to support only computer
equipment. You will overload your UPS if you
connect household appliances, laser printers
or surge suppressors to the UPS’s output.
• Turn utility power off before connecting it to
the input of your UPS.
• Connect the incoming ground wire to the
GROUND IN (green & yellow) terminal.
• Connect the outgoing ground wire to the
GROUND OUT (green & yellow) terminal.
• Connect the incoming hot wire to the HOT
IN (brown) terminal.
• Connect the incoming neutral wire to the
NEUTRAL IN (blue) terminal.
• Connect the outgoing hot wire to the HOT
OUT (black) terminal.
• Connect the outgoing neutral wire to the
NEUTRAL OUT (white) terminal.
• Turn utility power on. Your UPS will enter
STANDBY mode. The LINE POWER
“
” LED will begin flashing. The UPS
system’s output will not be active until the
UPS is turned ON.
Turn your UPS ON
• Press the POWER button
• Hold the button for a moment, until the
LINE POWER “ ” LED stops flashing
and illuminates constantly
• Release the button
Your UPS is now ON and its AC output
is active.
1
2
1
2
200208100 93-2041 OM500RMX Manual.qxd 9/11/2002 3:09 PM Page 4