TechniSat DIGIT MF4-S - Manual (Page 67)

SFI data:
SFI preview:
maximum 7 days in advance
Timer:
Events:
maximum 30 events, one year
in advance
Remote control system: RC-5
Subsystem address 8 (SAT 1), 10 (SAT 2)
Modulation frequency 36 kHz
Infra-red wavelength 950 nm
Power supply:
Mains power adapter:
Power requirement:
3,0 W
in stand-by mode (clock off)
3,4 W in stand-by mode (clock on)
10,5 W in operation, LNC off
18 W in operation, horizontal polarisa-
tion / 400 mA LNC power
Nominal voltage:
230 V / 50 Hz AC
Input voltage:
180 V.... 250 V / 50 Hz AC
General:
Dimensions (WxDxH):
285 mm x 133 mm x 40 ... 43 mm
Weight: approx. 490 g
12 Trouble-shooting guide
67
Problem Possible cause Solution
Current time not displayed while unit
is in stand-by mode Time not acquired Switch to major programme for
approx. 30 secs.
Receiver cannot be switched on, or
cannot be operated Receiver blocked Perform Flash Reset: Note! All per-
sonal settings will be lost.
>
Disconnect mains plug.
> Simultaneously press pro-
gramme up/down key on
receiver and keep pressed
down.
> While programme up/down
key is pressed, reconnect
mains plug.
> Keep keys pressed down for
approx. 5 secs. until message
* “FLAS” appears.