TechniSat DIGIT MF4-S - Manual (Page 48)

> Use the arrow keys up/down to mark the line All
Satellites, to scan all active satellites for programmes, or
mark the desired satellite, to scan only this for programmes.
> Confirm by pressing OK.
> Use the arrow keys up/down to mark the field Scan
mode.
> Press the OK key to decide whether you want to scan only
for free-to-air programmes ( Free) or whether you wish to
scan for encrypted programmes as well (All).
> Confirm by pressing the red function key Start scan.
The scan will be started. Please note any messages display-
ed on screen.
> You may abort the scan at any stage by pressing the red
function key.
8.4.3 Transponderscan
You may scan a specific transponder (see Point 10 Technical Terms)
for programmes. To do this, it is necessary to enter the transponder
data (Fig. 8-17).
Satellite
In this line, enter the satellite on which the desired transponder is
located.
> To do this, use the arrow keys up/down to mark the line
Satellite.
> Press the OK key to display a table showing all the active
satellites.
> Now use the arrow keys up/down to mark the desired
satellite.
> Confirm by pressing OK.
The selected satellite will now be displayed in the line
Satellite.
Transponder frequency
> Use the arrow keys up/down to mark the line
Transponder frequency.
> In this line use the numeric keys to enter the desired fre-
quency.
Symbol rate
The symbol rate indicates the volume of data transmitted per second.
This could be, for example, 27500 (27500 symbols per second).
> Use the arrow keys up/down to mark the line Symbol
rate.
> Use the numeric keys to enter the appropriate symbol
rate.
48
(Fig. 8-17)