TechniSat DIGITY 1 - Manual (Page 34)

Memory capacity:
FLASH memory 0,5Mbytes
SDRAM (CPU) 2 MBytes
SDRAM (CPU) 2 MBytes
EEPROM 1 kByte
Audio Parameters:
Input analogue:
Input levels L/R 0,5 V r.m.s. (nominal)
Input impedance > 40 kOhm
Output analogue:
Output levelsl L/R 0,5 V r.m.s. (nominal)
Output impedance 600 Ohm
THD > 60 dB (1 kHz)
Crossover < - 65 dB
Initial volume Memorizes last set value
Video Parameters:
Input:
Input level FBAS 1 Vs-s +/- 0.3 dB into 1 kOhm
Input level RED 0,7 Vs-s +/- 0.1Vp-p into 75 Ohm
Input level GREEN 0,7 Vs-s +/- 0.1Vp-p into 75 Ohm
Input level BLUE 0,7 Vs-s +/- 0.1Vp-p into 75 Ohm
Video/Tele text
Tele text filtering corresponding to ETS 300 472 standard
Reading in tele text files (FBAS) corresponding to ITU-R BT.653-2 lines: 6-22 and 320-335
TV-SCART:
Output: switchable FBAS or RGB r
VCR-SCART:
Eingang: FBAS oder RGB
Output: FBAS
Serial Interface RS 232:
Type RS 232, bi-directional
Bitrate 38,4 kBit/s
Connecting plug D-SUB 9 pin plug
Function Updating of operational software
LNB Power supply:
LNB current 400 mA max.; double insulated
LNB voltage vertical <14,0V no load, > 11,5 V at 400 mA
LNB voltage horizontal < 20V no load, > 17,2 V at 400 mA
LNB switched off in standby mode
22 kHz-Modulation: 22 kHz, amplitude 0.6 V +/- 0.2 V
Programme memory/Satellite positions:
500 TV programmes
500 RADIO programmes
34
bed_anl_DIGITY 1_englisch_4.qxd 21.06.02 13:41 Seite 34