Toshiba FT-8001 AW - Manual (Page 9)

8
Wall mount template
IMPORTANT:
Before mounting, select a wall area of sufficient
strength. If mounting on wallboard or in an area
of questionable strength, locate a stud for
maximum support of your telephone.
Avoid electrical cables, pipes, or other items
behind the mounting location that could cause a
hazard.
CUT CUT
•
•
• Route the cords through the guides.
• Place the base unit on the posts of the wall plate and push down until
it is firmly seated.
• USE ONLY WITH Supplied AC ADAPTOR (TAC-8001 power source
AC 120V, 60Hz/DC 9V).
Notes
• Do not use any outlet controlled by a wall switch.
• If you don’t have a standard wall plate, cut out the template on this page and use it to position
two screws (minimum length of 1 3 /
8
inches) into the wall with the heads protruding about 1/4
inch.