Toshiba FT-8001 AW - Manual (Page 13)

12
3. INTERFERENCE OR STATIC
If you hear noise during a call, press CH to select another channel.
The TALK/BATT LOW LED blinks while changing a channel.
4. CHANGING THE RINGER VOLUME
Press VOL/RING to select one of four ringer tone and volume combinations
during standby mode.
Each time you press
VOL/RING , the setting will change.
5. CHANGING THE HANDSET SPEAKER VOLUME
During a telephone call, press VOL/RING to select one of three speaker
volume levels; Low, Medium and High.
The setting will remain in effect even after you hang up the current call.
Note
The High setting may be too loud because it is set for hearing aid compatibility.
6. REDIALING
Press TALK and then press
RDL/P
(Redial/Pause). The last number
called (up to 32 digits) will then be dialed again.
7. USING THE CALL WAITING SERVICE, ETC.
To use this feature, you must subscribe to the Call Waiting service.
When you hear a call-waiting tone while you are already talking on the
phone, simply press
FLASH .
To take the original call back, press
FLASH
again.
Note
Pressing FLASH without receiving a Call Waiting signal may disconnect the current caller.