Toshiba FT-8001 AW - Manual (Page 11)

10
Please see “LOCATION OF CONTROLS” for the location of
each button used for the following operations.
SETTING THE DIAL MODE
Most phone systems use tone dialing. But, to use tone dialing, you
must have a tone service dialing system supplied by your telephone
company. Then you must set your telephone dial mode for the type of
service you have. If you are not sure which type of service you have,
do the following steps.
q With the phone in the Standby mode, press and
hold
FLASH
until you hear a confirmation tone.
w Press
TONE/ .
You hear a confirmation tone.
e Press
TALK and listen for a dial tone.
r Press any number other than 0.
If the dial tone stops, you have tone service
and your setting is complete. If the dial tone
continues, you have pulse service and you must
perform steps 5 and 6 below.
t With the phone in the Standby mode, press and
hold FLASH until you hear a confirmation tone.
y Press
# and hear a confirmation tone. Your
setting is complete for pulse service.
3
1, 5
6
2