Tascam 302mkII - Manual (Page 16)

16
TASCAM 302MKII
9. Adjust the INPUT control on deck 2 of the master
so the meter reading is around 0 dB. Balance the
left and right input levels with the
REC BAL
control.
10. Set the DOLBY NR switch on deck 2 of the master
to the desired position.
All the slave decks configure themselves to the
level and balance on deck 2 of the master. Settings
on the individual decks are overridden.
11. To start recording, press the Á button on deck 2
of the master.
If the tape on deck 2 of the master reaches the end
of the forward side before any tapes on the slaves,
recording continues on these tapes up to the end of
their forward sides.
You can interrupt recording on all the decks by
pressing
STOP on deck 2 of the master.
12. When all the tapes reach the end of their forward
sides, hold down RECORD and press PAUSE on
deck 2 of the master to put all the decks into
Record Ready mode.
13. Press the Ó button on deck 2 of the master so that
all the tapes are ready for recording on their
reverse sides.
14. To continue to record, press the Ó button once
more on deck 2 of the master.
15. To terminate recording, press STOP on deck 2 of
the master.
Multiple-unit System Operation