Toshiba DKA-UG-DKSLT-VB - Manual (Page 41)

Features
Message Waiting
32
Strata DK Digital Single Line Telephone 5/99
Retrieve a Call on Hold
Retrieve a Call on Exclusive Hold
Message Waiting
If your station is idle or busy on a call while another station tries to contact you, the
calling station can turn on the message waiting LED on your telephone. Your Message
Waiting lamp flashes when there is a message.
When you respond by pressing 0VJ , you will either hear a voice message or your
phone will dial the telephone which set a callback message. Voice mail devices and
stations can leave message waiting indications.
Up to four Message Waiting indications can be left at a station at one time. One of the
indications is for the Message Center.
➤ To answer a Message Waiting light
➤ Press /LQH again. If a call is not retrieved by a certain time (set in system
programming), it recalls back to your phone. You hear repeated
recall tone (or if you are on the phone, you hear recall tone twice).
If the held party hangs up, the call is released and the CO provides a
hold-release signal.
➤ Press /LQH again. If a call is not retrieved by a certain time (set in system
programming), it recalls back to your phone. You hear repeated
recall tone (or if you are on the phone, you hear recall tone twice).
If the held party hangs up, the call is released and the CO provides a
hold-release signal.
1. Lift the handset and
press 0VJ.
You hear dial tone after lifting the handset.
Your phone rings the device that set the indication. If there is no
answer, hang up and try later. (The LED continues to flash.)
...or lift the handset
and press
/LQH
+
.