beautypg.com

Technical specifications – Tyco CEM Systems DIU 220 User Manual

Page 2

background image

Physical

Size

160 x 160 x 90 mm

(6.3 x 6.3 x 3.5in)

Weight

0.75Kg

Housing

Flame retardant polycarbonate

Colour

Light grey with transparent lid

Power

From High power midspan device

(PowerDsine Midspan)

Environmental
- Temperature

up to 50ºC (up to 122ºF)

- Humidity

95% non condensing

LED Indicators

+12 Volts OK, Lock supply OK, Lock Status,

Watchdog, Fault, Battery Low, RS485 Rx

and TX.

Functionality

Inputs

* Door Position

* Lock Status

* Exit Push Button

* General Purpose

* = 4 state tamper protected inputs

Outputs

Three 11.5V open collector outputs limited

to 1.5A (Door Lock, Door Holder and

External Sounder)


Reader Output

11.5V, limited to 800mA

Memory

32kB Flash memory

communication interFace

To Card Reader

Ethernet and RS485 cable

- Connection

RJ45 and 2 part screw terminals

ProDuct coDe

DIU/700/220 DIU 220 (Complete with PoE backplane

and enclosure)

CEM Systems Ltd Unit 4 Ravenhill Business Park Ravenhill Road Belfast BT6 8AW Northern Ireland

Tel: +44 (0)28 9045 6767 Fax: +44 (0)28 9045 4535 email: [email protected]

www.cemsys.com

PRODUCT HIGHLIGHTS

CEM/B/047 Rev B

Product specifications and availability is subject to change without notice. Certain product names mentioned herein may be trade names
and/or registered trademarks of their companies.
† Diagrams shown are for illustrative purposes only. Refer to product manual for recommended cabling.

technical sPeciFications

Power over ethernet access control

DIU 220 incorporates a High power PoE splitter module,
delivering sufficient power and Ethernet communication
to reliably power a complete door set (consisting of In
and Out readers 650mA Maglock, door holder, sounder and
strobe) using one CAT 5/6 Ethernet cable.

Benefits

The DIU 220 offers a complete IP based access control
solution. Eradicating the need to provide local mains
power and AC/DC power supplies at the door, the DIU
220 installation is classed as low voltage and can be
completed by IT network installers without the expense of
an electrician or electrical contractor.

low cost exit solution

The DIU 220 incorporates a weigand interface which
allows a 3rd party weigand read head to be directly
connected. This provides a low cost alternative if an LCD
and keypad are not required for the exit side of the door.

DIU 220

DIU 220

† see dislosure below