Administrator settings, The ip settings menu, Codec c90 administrator guide – TANDBERG Codec C90 D14129.02 User Manual
Page 17
D14129.02—NOVEMBER 2008
17
Codec C90
Administrator Guide
Contents
Introduction
Getting started
About the menus
About the settings
Settings Library
Cameras
Appendices
Contact us
Admin. Settings menu
Administrator settings
The Administrator settings menu lets the user
configure the IP settings and the system settings.
The IP Settings menu
The IP Settings are found in the
IP Settings
menu
as well as in the Advanced Configuration menu in
the Network settings.
!
Changes in the administrator settings may
affect the behavior of the system and should
be configured by the system administrator.
Each setting is explained in the
administrator
The settings library
section.
Navigate in the menus
Use the remote control to navigate in the menus:
Use the arrows down/up to select a menu item
•
Use the arrow right to expand the selection
•
Use the arrow left to go one step back
•
Change a value
Select a value from a drop down list and press
•
the OK button to save, or press the left arrow to
leave without saving.
Enter a value/text in a value/text field. Press
•
Save to save the change or Cancel to leave
without saving.
If
IP Assignment
is set to
DHCP
the IP
address, Subnet Mask and Gateway
will automatically be assigned to the
codec from the DHCP server.
If
IP Assignment
is set to
Static
the IP
address, Subnet Mask and Gateway
must be defined manually:
On the remote control, press
•
the arrow down key to highlight
an address field. Enter the IP
address, Subnet Mask and
Gateway address.
Press OK to confirm the new
•
value or Left arrow to cancel.
In this guide we will concentrate on what’s behind
the
Administrator Settings
menu and leave the
other menus to be explained in the Codec C90
User Guide.
You can download the Codec C90 User
Guide from our web site.
Go to:
ADMINISTRATOR SETTINGS
SETTINGS
HOME
IP SETTINGS
IP SETTINGS
Static
DHCP
!
Changes in the administrator settings may
affect the behavior of the system and should
be configured by the system administrator.