beautypg.com

Turn on the system, Verify ip address settings, If you need to set a static ip address – TANDBERG Codec C90 D14129.02 User Manual

Page 11

background image

D14129.02—NOVEMBER 2008

11

Codec C90

Administrator Guide

Contents

Introduction

Getting started

About the menus

About the settings

Settings Library

Cameras

Appendices

Contact us

Getting started

Turn on the system

Turn on the codec and wait a few minutes for the system to start

Make sure the remote control has the batteries installed.

Press

Home (

) on the remote control to show the menu on screen

When you can see the menu on screen, proceed to Step 2.

Show the menu:

Press

Home (

) on the remote control to show the menu on screen

Navigate in the menu:

Use the arrow keys on the remote control to navigate up and down in

the menus

Confirm your choice:

To confirm your choice, press

OK (

) on the remote control

1

3

If you need to set a static IP address

Go to IP Settings to set static IP addresses:

Navigate to Settings > Administrator Settings > IP Settings.

1.

Set IP Assignment to Static. Press the left arrow key to go back one step

2.

Enter the IP Address, Subnet Mask and Gateway address in the address fields.

3.

The sequence is shown below.

Press

4.

OK to save the changes, or Cancel to leave without saving.

Press

5.

Home (

) to exit.

Verify IP address settings

Go to System Information to verify the IP address:

Navigate to Settings > System Information

1.

When the IP address is automatically assigned from a DHCP server, the

2.

Address of the codec is shown on the System Information page.

Press

3.

Home (

) to exit.

2