beautypg.com

Preface, About this guide – Toshiba EVR64-X User Manual

Page 15

background image

xiv

Preface


About this Guide

This manual is a setup and maintenance guide that can be used for reference when setting up
the DVR unit and for troubleshooting when a problem occurs. Only authorized personnel should
attempt to repair this unit.

Toshiba reserves the right to make changes to the DVR units represented by this manual
without notice.


The following text and symbols mark special messages throughout this guide:

WARNING:

Text set off in this manner indicates that failure

to follow directions could result in bodily harm or loss of life.

CAUTION:

Text set off in this manner indicates that failure to

follow directions could result in damage to equipment or loss
of information.

NOTE:

Text set off in this manner indicates topics of interests that

can help the user understand the product better.

TIP:

Text set off in this manner indicates topics and points of

interests that can be helpful when using or settings up the DVR unit.

Technician Notes

WARNING:

Only authorized technicians trained by Toshiba should attempt to repair this DVR unit. All

troubleshooting and repair procedures that may be shown are for reference and minor repair only. Because of the
complexity of the individual components and subassemblies, no one should attempt to make repairs at the
component level or to make modifications to any printed wiring board. Improper repairs can create a safety hazard.
And any indications of component replacement or printed wiring board modifications may void any warranty.

WARNING:

To reduce the risk of electrical shock or damage to the equipment:

Do not disable the power grounding plug. The grounding plug is an important safety feature.

Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.

Disconnect the power from the computer by unplugging the power cord either from the electrical outlet or
the computer.

CAUTION:

To properly ventilate your system, you must provide at least 3 inches (7.6 cm) of clearance at the front

and back of the DVR unit.