Timex 568-095003 - Manual (Page 7)

11
Chrono Mode (Chronograph or Stopwatch)
The Chronograph (Chrono) will
time events up to 100 hours. It will
store to memory the lap number,
lap time, split time, average speed,
average pace and distance for each
lap taken.
A lap time is the time for a segment
of an event. A split time is the total
time from the beginning of an
event.
Data displayed in CHRONO mode for Average Speed, Maximum Speed,
Average Pace, Best Pace and Distance are based only on information
received since the chrono was started.
You can go to other modes while the Chronograph is running. In the Time
display, a stopwatch symbol will appear on the display to indicate the
Chrono is running.
A. Press START to begin timing.
B. Press STOP to stop timing.
C. Press START to resume timing OR
D. With Chrono stopped, press and hold RESET to reset display to zero.
To Set or Adjust Time Zone 1:
A. Press SET. Hold to Set appears.
B. Continue holding until Set Time appears. Hours will begin flashing.
Press START to advance the flashing digits.
C. Press MODE to set (in order): MINUTES; DAY OF THE WEEK; MONTH;
DATE; 12- OR 24-HOUR FORMAT; HOURLY BEEP ON/OFF; BUTTON
BEEP WHEN PRESSED ON/OFF. The selected item will flash. Press
START to change. In 12-hour format, go through 24 hours to change
from AM to PM.
D. Press SET to save changes and exit Set Time.
To Change Time Zone Display:
A. Press START to view Time Zone 2 display. Release the button if you
only want to peek at Time Zone 2.
B. Press and hold START for 6 seconds and Time Zone 2 becomes primary
display.
C. Follow steps A through D above to set Time Zone 2.
NOTE: Seconds cannot be manually changed.
To View Time of Day and Speed and Distance:
With the Transceiver functioning and while six feet from other people, press
SPEED/DISTANCE DISPLAY button to begin displaying data. Press it
repeatedly to select the data to view.
10