Timex 568-095003 - Manual (Page 11)

19
Options Mode
The watch has a variety of options
designed to make the Speed and
Distance System more useful.
In Options Mode, press
SPEED/DISTANCE DISPLAY to
review the option settings.
To adjust non-numeric options (like
On/Off, Units, Speed or Pace, etc.),
you can simply press START to choose the correct setting.
To change numeric settings:
1. Press and hold SET to start the set sequence. The value (or some part of
it) will begin to flash.
2. Press START to set the flashing value, and use MODE to select the next
digit. Note that some options only have one setting or digit, so MODE
does nothing.
3. When you are done setting, press SET to save the changes and exit
setting.
SMOOTHING – This feature makes pace and speed values easier to read
while using the watch by “smoothing” out any small variations in speed.
You might want to enable this feature if you are viewing pace information
and the displayed numbers appear too “jumpy.” Smoothing has no effect
on the accuracy of the data displayed, nor any effect on the distance
accumulated.
Alarm Mode
You can set the alarm for every
day, for only weekdays, or for
only weekends. The alarm will
operate for whichever Time Zone
is selected as the primary time
display. At the set time, the alarm
tone will sound for 20 seconds,
INDIGLO
® display will flash, and
the alarm display will pop up for
20 seconds. If no action is taken, a backup alarm will sound 5 minutes
later. When the alarm sounds, pressing any button will silence the alarm.
A. In Alarm mode, press SET. The HOURS value will flash.
B. Press START to change the flashing display.
C. Press MODE to change TENS OF MINUTES, then again to set MINUTES,
and again to set Alarm type (Daily, Weekday or Weekend).
D. Press SET to save and exit Set Alarm mode.
Alarm ON or OFF Setting:
In Alarm mode, press START to turn alarm ON or OFF. When Alarm is ON,
an alarm clock icon appears on the watch display in Time of Day Mode.
18