Timex 568-095003 - Manual (Page 6)

9
Operating the Speed & Distance Watch
Push MODE to scroll through the following modes in this order:
Time of Day • Chronograph • Chronograph Recall • Countdown Timer
• Speed and Distance Monitor • Odometer • Alarm • Options
Automatic Time Correction and Setting:
If the watch is receiving GPS data from the transmitter, the system
automatically corrects the time and sets the date based on the highly
accurate time used by the GPS satellites.
• If you have never set the time on the watch, the system will set the watch
to UTC (Greenwich Mean Time).
• If you have set the time before first using the Transceiver, it will change
your time to UTC time. You may then need to adjust for your time zone.
• If you have adjusted the time since using the Transceiver, the system will
maintain your adjustment and only correct itself for time it has drifted
since you last used the Transceiver. (For example, if you set your watch
five minutes fast, the system will adjust the time so it is exactly five
minutes fast.)
Displaying Speed + Distance Data
Press the SPEED/DISTANCE DISPLAY button while standing 6 feet from
other users of this system to begin displaying data. The watch will display
a wave symbol in the upper left part of the watch display. If the Transceiver
is still searching for satellites, the watch shows SEARCHING. Once the
search is complete you can use the Speed and Distance features of the
watch.
In Time, Chronograph, Timer, and Monitor modes, press SPEED/
DISTANCE DISPLAY button repetitively to view information in this order:
SPEED (current), AVERAGE SPEED, MAXIMUM SPEED, PACE, AVERAGE
PACE, BEST PACE, DISTANCE.
Information in each mode is accumulated independently.
You can manually turn off Speed and Distance data by holding down the
SPEED/DISTANCE DISPLAY button for 2 seconds.
8