Topcom BUTLER 4850 - Manual (Page 21)

Topcom Butler 4850/Twin/Triple/Quattro 21
Topcom Butler 4850/Twin/Triple/Quattro
ENGLIS
H
11.11 Erasing Messages
11.11.1 Erasing Messages One at a Time during Playback
Start message playback as explained above.
•
When the message to be erased starts playing, press the delete key for 2 secs
• The display will show ‘dL’.
• Press the delete key again to confirm.
11.11.2 Erase all messages
One can also erase all heard messages at one time. This erases only the messages that
have already been heard. New messages are not erased.
•
Press the delete key for 2 secs.
• The display will show ‘dL’.
• Press the delete key again to confirm.
11.12 Memory Full
If the memory is full, ‘FL’ will flash on the display. If the answering machine is turned on and
a call comes in, the machine will automatically play OGM 2 (answering machine function
without recorded caller message).
•
Erase all the messages after listening to them.
• The memory is free again.
11.13 Remote Operation
The answering machine can only be operated remotely using a tough-tone phone (DTMF
tone selection system).
•
Call your machine.
• The answering machine picks up the line, you hear the outgoing message and a beep.
• After the beep, slowly dial the VIP code (default 321).
• You will hear two short beeps for confirmation.
• Enter the next codes to use the desired function:
a) Listening to Messages
•
Press ‘2’ (listen to messages). The answer machine will play the messages.
During playback, you have the following options:
•
Press ‘2’ to stop playback.
• Press ‘2’ to restart playback.
• Press ‘3’ to go to the next message.
• Press ‘1 1' to go to the previous message.
• Press ‘1’ to repeat the current message.
• Press ‘6’ to stop playback.
• Press ‘7’ to erase the current message.
b) Erasing All Old Messages
After listening to all messages, press ‘0’ to erase all messages.
c) Playing Outgoing Message
•
Press ‘4’ to play the current outgoing message.