Topcom BUTLER 4850 - Manual (Page 15)

Topcom Butler 4850/Twin/Triple/Quattro 15
Topcom Butler 4850/Twin/Triple/Quattro
ENGLIS
H
8 Register/de-register a handset
8.1 Register to a Topcom B4850 base
You can subscribe 4 handsets to one base unit. By default, each handset is subscribed as
handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if:
•
The handset subscription has been removed from the base unit (e.g. for reinitialisation)
• If yYou want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Butler 48xx handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator
on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly for one
minute. During this minute, the base unit is in register mode and you must do the following
to subscribe the handset:
Press Menu button
ÆUse the Right button to scroll to ‘REGISTER’ and press OK
Æ Enter the number of the base unit you would like to subscribe the handset to (1-4) Æ The
unit will start searching for the base and when found it will ask to enter the pin code (4 digits):
Æ Enter the base pin code (0000) and press OK . Æ If the pin is wrong, the handset will
restart the searching for the base.
Æ When the handset is registered, it will show ‘HS’
followed by the handset number.
8.2 Removing a handset
You can remove a handset from a base to allow another handset to be registered:
Press Menu button
ÆUse the Right button to scroll to ‘REMOVE HS’ and press OK
Æ Enter the pin code (0000) and press OK Æ Enter the handset number (1-4) you
want to remove and press OK .
Æ The unit will go back to standby is the removal is
successfully. If not, it will ask again to enter the handset number
You can only remove existing handsets and others then the one you are
using.