Toshiba e-STUDIO35 - Manual (Page 15)

TOSHIBA e-STUDIO28/35/45 Unix Printer Driver
User’s Guide 7
system errors when launching the setup installation program directly on systems
without Motif support.
The install installation script will show an error message if it cannot find the Motif
library in the system, except for Linux, where the driver is built to run even on
systems without Motif support. If you are sure that you have Motif installed in the
system, you can use the setup installation program directly.
The install installation script assumes pre-defined libraries for determining
whether the systems supports Motif or not.
The script checks if the libraries below exist in their specified locations:
Platform Library location
HP-UX /usr/lib/libXm.2
Sun Solaris (SPARC)
/usr/lib/libXm.so.4
Sun Solaris (Intel) /usr/lib/libXm.so.4
IBM AIX /usr/lib/libXm.a
Red Hat Linux None
If not, the script will show an appropriate message.
If you think Motif is installed in the system, you can also try running setup
installation program directly on the command line: ./setup
• If it fails (crashes), please take note of any error message you get from the
system and send it to us. This would help us update the install script to reflect
whatever library or file the setup installation program may require to run
successfully in your system.
• BUT if setup runs and shows the user interface, that could mean that it has
found the Motif library somewhere in your system, meaning, you have a
different location than /usr/lib for the Motif library. In this case, you can
modify the install script to reflect this library path. You can contact us if
you like us to do this update for you – just inform us the correct library path
for your target system.
Syntax
./install [-uh] [[q:]] [s:] [p:]
[t:] [g:] [cdepth:]
To run setup directly, use “setup” in the same syntax, as:
./setup [-uh] [[q:]] [s:] [p:] [t:]
[g:] [cdepth:]
If no parameter is specified, this launches the setup installation program in
graphical install mode.
Parameters that are enclosed in square brackets are optional.