Thule Transport T2 - Manual (Page 5)

9490-A T2 Instruction Manual
Page 5 of 12
Transport T2
Hitch Mount Bicycle Rack
Assembly & Use
Folding your Bike Rack:
A) Once your bike is loaded shake the bike
to make sure the support arm is seated
correctly
.
WARNING: The support arm v-notch
must be firmly seated against the tire
and brake, or fork. Failure to seat the
support arm securely may result in bike
instability. Always shake your bike after
loading to ensure the hook arm is fully
seated.
A) To fold your bike rack up against your
vehicle, pull the green latch handle at the
base of the rack while gently lifting the rack
to release the latch bar.
Fig N.
B) Once the square latch bar is released,
lift the rack up until the latch bar snaps into
place on top of the quadrant
.
Fig N.
C) If you notice any interference with
the vehicle please refer to Fit Tips on
page 5 for solutions
.
A) To drop your rack down, remove the
safety pull pin first (Fig O.) and then pull
the latch handle to release the square
bar
. (Fig N.) The rack can then be
lowered to the ground for access to the
back of the vehicle
.
A) Latch bar
B) Quadrant Latch Bar Slot
A) Safety pull pin
Figure M .
Figure O.
Figure N.