Transport t2 – Thule Transport T2 User Manual
Page 2

9490-A T2 Instruction Manual
Page 2 of 12
Transport T2
Hitch Mount Bicycle Rack
Assembly & Use
To prepare your rack for installation…
Fig A-1
Fig A-2
Out of the box:
1. To prepare your rack for installation, remove the bolt, nut and washer from the rear linkage
bars using a ¾” wrench(see Fig A-1).
2. Swing the hitch base 180 degrees and line up the bushings in the middle hole with the rear
linkage bars(Fig A-2).
3. Replace the bolt, nut and washer and tighten(Fig A-2).
Tools Required for Assembly:
6mm Allen Wrench (included), ¾” wrench and a 15/16” wrench. NOTE: All fasteners are
pre-installed for easy assembly.
2. Middle hole
1. Bolt, Nut and washer to
remove
2. Rear linkage Bars
2. Hitch Base
3. Replace Bolt,
nut and washer.
- Passage 910 (26 pages)
- Locking Ladder Holder 349 (8 pages)
- 2022 (1 page)
- 103 (1 page)
- 4002XT (6 pages)
- 239 (1 page)
- 123 (1 page)
- WHEEL-ON 593 (3 pages)
- 2008 (1 page)
- Time Travel Series 669TT (7 pages)
- 332 (7 pages)
- 2016 (1 page)
- 186 (1 page)
- 059 (1 page)
- 598 (7 pages)
- 460R (5 pages)
- 118 (1 page)
- 056 (1 page)
- 180 (1 page)
- 231 (1 page)
- 082 (1 page)
- Railing Foot Pack 415 (5 pages)
- 2059 (1 page)
- 188 (1 page)
- 167 (1 page)
- Long Tray Classic 591 (6 pages)
- 169 (1 page)
- 247 (1 page)
- 2011 (1 page)
- 542 (3 pages)
- Ladder Lift 329 (16 pages)
- 177 (1 page)
- 218 (1 page)
- Outrigger II 847 (6 pages)
- 109 (1 page)
- Transporter Combi 665C (10 pages)
- Rapid Aero Foot Pack 400XTR (8 pages)
- 2080 (1 page)
- Kit 110 (2 pages)
- Set-to-Go Saddle 878xt (6 pages)
- 2060 (1 page)
- 156 (1 page)
- 2056 (1 page)
- 91725 (4 pages)