Tascam US-122MKII - Manual (Page 19)

TASCAM US-122MKII
19
CAUTION
Connecting a dynamic mic with an •
unbalanced connection could damage it
if the PHANTOM switch is ON.
Do not connect or disconnect mics when •
the PHANTOM switch is ON. Doing so
could cause loud noise or damage the
equipment.
Use the PHONES/LINE OUT knob to •
minimize the volume before turning the
phantom switch ON or OFF. Depending
on the mic, loud noises might be
produced and damage could be caused
to equipment or to people’s hearing.
NOTE
When the PHANTOM switch is ON the •
PHANTOM indicator lights on the top
panel.
The pin configuration of the unit's XLR •
connector is:
Pin 1 = Ground
Pin 2 = Hot
Pin 3 = Cold
Guitar
Connect your guitar to the R -channel LINE/
GUITAR IN jack (1/4” phone jack) on the
front panel and set the MIC/LINE-GUITAR
switch on the top pannel to GUITAR .
Keyboard/drum machine/sound
module/cassette deck/MD/CD etc.
(analog connection)
Connect the analog audio output of these
devices to the
LINE IN L or LINE/GUITAR IN
R jacks (1/4” phone jack) on the front panel.
If you use the R -channel, set the MIC/LINE-
GUITAR switch on the top panel to MIC/
LINE .
Guitar
Keyboard/
drum machine/
sound module/
cassette deck/
MD/CD or similar
device
OUT
5 – Connections