Tripp Lite OmniPro500 - Manual (Page 6)

6
Specifications
OmniPro 500
Output Capacity (VA/Watts): 500/300
Battery Runtime (Half Load/Full Load) Minutes: 17/5
Typical Runtime (Desktop PC/15 in. monitor) Minutes: 30
Battery Recharge Time (Hours): 2-4
Approvals: UL, cUL, NOM
Modem/Fax Protection (starts at 260V): 1 line
Input Voltage/Frequency (120V/60 Hz); On-Line Input Voltage Range (98 - 140 volts); Voltage-Regulated Output Voltage Range
(120V ± 5%); On Battery Output Voltage Range (120V ± 5%); Output Waveform Line Mode (filtered sinewave); Output Waveform Battery
Mode (PWM sine wave); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40 dB);
AC Protection Modes (H to N, H to G, N to G).
Storage & Service
Storage
First turn your UPS OFF and disconnect all equipment. Then disconnect its
power cord from the wall outlet. If you plan to store your UPS for an extended
period of time, fully recharge the UPS batteries once every three months by
plugging the UPS into a live AC outlet, and letting the UPS charge for 4-6 hours.
If you store your UPS without charging for an extended period of time, its
batteries will suffer a permanent loss of power capacity.
Service
If returning your UPS to Tripp Lite, please carefully pack the UPS using the
ORIGINAL PACKING MATERIAL that came with the unit. Enclose a letter
describing the symptoms of the problem. If the UPS is within the 2 year warranty
period, enclose a copy of your sales receipt.
200003008 OmniPro 500 Owner's Manual.p65 3/30/00, 2:39 PM 6