Tiger JD 62-6430 - Manual (Page 40)

JD6030 SNOW PLOW Parts Section 5-2
The following instructions are offered to help eliminate needless delay and error in
processing purchase orders for the equipment in this manual.
1. The Parts Section is prepared in logical sequence and grouping of parts that
belong to the basic machine featured in this manual. Part Numbers and
Descriptions are given to help locate the parts and quantities required.
2. The Purchase Order must indicate the Name and Address of the person or
organization ordering the parts, who should be charged, and if possible, the serial
number of the machine
for which the parts are being ordered.
3. The purchase order must clearly list the quantity of each part, the complete
and correct part number, and the basic name of the part.
4. The manufacturer reserves the right to substitute parts where applicable.
5. Some parts may be unlisted items which are special production items not
normally stocked and are subject to special handling. Request a quotation for such
parts before sending a purchase order.
6. The manufacturer reserves the right to change prices without prior notice.
NOTE: When ordering replacement decals, refer to the part numbers and
descriptions listed in the safety section in the front of this manual.
For maximum safety and to guarantee optimum product reliability,
always use genuine
Tiger
replacement parts. The use of inferior
replacement parts may cause premature or catastrophic failure
which could result in serious injury or death.
Direct any questions regarding parts to:
Tiger Corporation
3301 N. Louise Ave.
Sioux Falls, SD 57107
1-800-843-6849
1-605-336-7900
PARTS ORDERING GUIDE