Tekkeon MP1280 - Manual (Page 7)

USER GUIDE 5
case and the iPhone 4 back, it is very important
that you adhere the protector onto the back of
your iPhone 4. This will prevent any scratches
on the back when the iPhone 4 is in or out of our
battery case. Additional myGuard protectors are
available online at www.tekkeon.com.
1. Ensure that your iPhone 4 is free of dust.
2. Holding the red label , peel the first
backing from the myGuard protector.
3. Position and adhere myGuard to the back of
your iPhone 4.
4. Run your hand across the back to smooth
out any bubbles.
5. Holding the black label , peel the second
backing from the myGuard protector.
6. Repeat steps 1 through 5 to adhere the
myGuard protector to the front of your iPhone 4.
Placing Your iPhone 4 into the Battery Case
1. Holding the control module, gently pull the
battery module from the control module to
separate the two pieces.
2. Slide your iPhone 4 into the control
module, ensuring that it is fully docked
onto the 30-pin connector in the bottom
of the module.