Tekkeon MP1280 - Manual (Page 13)

USER GUIDE 11
Ultra Power battery which more than doubles
your work or play time on your iPhone 4.
1. With the iPhone 4 in the battery case, gently
pull the battery module from the control
module and iPhone 4.
2. Slide the new battery module down over your
iPhone 4 until it snaps into place.
Note: You must charge your extra battery before
swapping it while on the go.
Troubleshooting
If myPower for iPhone 4 does not power
iPhone 4, take these steps:
1. Confirm that the On/Off switch is in the On
position (to the right).
2. With the iPhone 4 inserted in the battery
case, check the Capacity Indicator to verify
that myPower for iPhone 4 is charged
(capacity indicator is blue).
3. Verify that your iPhone 4 is properly docked
into the 30-pin connector at the bottom of
the battery case and the battery module is
snapped securely into the control module.