Toshiba BDK2300KU - Manual (Page 15)

15 Blu-ray Disc™/DVD player connections
Do not drop or expose the remote control to electric shock.
Do not expose the remote control excessively hot or humid places.
Do not spill water or place anything wet on the remote control.
Do not open the remote control.
If the remote control is not going to be used for a long period of time, remove the battery to
avoid damage caused by battery leakage corrosion.
Direct the remote control at the remote sensor of the Blu-ray Disc™/DVD player.
When using the remote control, press the buttons at intervals of approximately 1 second to
ensure the correct mode of operation.
Blu-ray Disc™/DVD player connections
Connecting to a TV using an HDMI ® cable
This connection provides better picture quality and supports up to 1080i/1080p, 1080p/24F
resolution.
Connect an HDMI
® cable from the HDMI ® output jack on the player to the HDMI ® input jack on
the TV.
(Sample Illustration) Connecting to a TV - HDMI ® cable
HDMI ® connection is required. (HDMI ® cable sold separately).
Analog connection is not supported.
Do not tilt the connector when inserting it into the HDMI
® jack, and make sure the shapes of
the jack and the connector are matched.
When using a non-HDCP compatible TV, the image may not display properly.
An HDMI ® cable carries both video and audio signals. If you wish to use TV speakers, you do
not need to make an additional audio connection if you are using an HDMI ® cable.
Connecting to a digital amplifier/AV receiver
Route the sound from this player to other device to enhance audio output.
❖
Connect a coaxial cable from the Coaxial Digital jack on the player to the Coaxial jack on
the device.
❖
If your AV receiver or amplifier has an HDMI ® jack, you can also connect the HDMI ®
cable to the HDMI IN jack on your AV receiver or amplifier.
High
Definition
TV