Toshiba SD-5970SU - Manual (Page 57)

60
Others
Operating a TV with the Remote Control
You can operate the basic functions of selected TVs using the supplied remote
control
Preparation
Follow the instruction of “To program the remote control” to set the brand code.
Point the remote control at your TV, and use
buttons as follows.
To program the remote control
1. Press TV to select TV mode.
2. While holding down PROGRAM enter the two digits
of your TV’s brand code (listed on page 61) using
Number buttons.
e.g. To program brand code 01.
3. Release PROGRAM.
The DVD remote control memorizes the selected
TV brand code.
POWER To turn the TV on or off.
INPUT SELECT To select external source
such as a VCR.
NUMBER buttons To select TV channel. When
selecting channels 1 to 9,
first enter 0 and then the
desired number.
100 To substitute for 100
channel key.
DISPLAY To turn on or off TV’s screen
display.
VOL + / - To adjust the volume.
CH +/ - To select a channel.
ENTER To use for the TV’s ENTER
key.
Notes
• The remote control is programmed at the factory to operate
TOSHIBA TVs.
• A single brand may use different codes depending on the
particular model. Enter the correct number referring to the
brand code table.
• For some brands, several brand codes are provided. Try
each of them until the remote control operates your TV.
• Some TVs may not respond to all of the functions in the
table above, or may not be operated at all with this remote
control.
• If you replace the remote control’s batteries, remember to
reprogram the brand codes for TV.
• To resume DVD functions, press DVD button once.
Operating a TV with the remote control
DISPLAY
CH, VOL
POWER
INPUT SELECT
Numbers/100
ENTER
1 0