Toshiba MW24FP1 - Manual (Page 42)

42
Other functions (VCR)
LINE 1 IN
VIDEO
AUDIO L(MONO)
R
VIDEO
AUDIO L
R
OUT PUT
DIGITAL AUDIO
VHF/UHF
COAXIAL
To AUDIO (R) IN
To AUDIO (L) OUT Audio/Video cable (not supplied)
Playback VCR
To VIDEO OUT To AUDIO (R) OUT
Recording VCR
Duplicating a video tape
If you connect the unit to another VCR or Camcorder, you can
duplicate a previously recorded tape. Make all connections before
turning on the power.
Duplicating a video tape
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer’s
instructions. A typical camcorder dubbing hookup is
shown above.
Audio/Video cable (not supplied)
To AUDIO (R) IN
To AUDIO (L) IN
To VIDEO IN
Recording VCR
To AV Jack
Playback Camcorder
Connection with Camcorder
• Select “LINE2” on step 2.
Press SP/SLP to select the desired tape speed
SP or SLP.
It is recommended that you set the
Speed to the SP mode on the
recording VCR for best results.
1
Press INPUT SELECT once or twice to select
AUDIO/VIDEO input position.
“LINE1” or “LINE2” will appear on the
screen.
2
Press PLAY on the playback VCR or camcorder.
3 Press both REC at the same time.
4
Press STOP after duplicating a video tape. 5
LINE1: on the rear panel
LINE2: on the front panel
Preparation:
• Press TV/VCR to select the TV/VCR mode.
• Load a cassette tape with the erase prevention tab
intact.
• Load a previously recorded tape into the playback
VCR or Camcorder.
LINE1
To VIDEO IN
To AUDIO (L) IN
SP/SLP
RETURN
INPUT
SELECT
ZOOM
Note:
Unauthorized recording of copyrighted television programs, films,
video cassettes and other materials may infringe the rights of
copyright owners and be contrary to copyright laws.
REC
3
TV/VCR
2
1
Connection with second video recorder
• Select “LINE1” on step 2.
Illustration of MW20FP1 STOP
STOP
5L00201C [E]p42-43 20/4/04, 16:07 42