Toshiba MW24FP1 - Manual (Page 40)

40
Recording (VCR)
Timer recording
Timer recording can be programmed on-screen with the remote control.
The built-in timer allows automatic unattended recording of up to 8
programs within 1 month.
Timer recording
Notes:
• Press to move cursor backward
for correction.
• To record from external source set
the channel to “L1” or “L2”.
Notes:
• The VCR section cannot be used while the TIMER REC in-
dicator is lit. If you want to use the VCR operation,press both
TIMER REC buttons at the same time to deactivate the timer.
• When the clock is not set, you cannot select “TIMER REC”.
In this case, set the clock (see pages 19~21).
• After a power failure or disconnection of the power plug,all
programmed recording setting and time display will be lost
upon resumption of power. In this case, reset the clock (see
pages 19~21) and reprogram any timer recordings.
• If you want to correct the digits while setting, press or
until the item you want to correct, then press or to
correct the desired setting.
• If programming is performed without a tape in the unit, or
with a tape without an erase prevention tab, the Timer Re-
cording is not possible. If a tape without an erase prevention
tab is in the unit, the tape will be ejected.
Press MENU, then press or to select
option.
Preparation:
• Press TV/VCR to select the TV/VCR mode.
• Load a cassette tape with the erase prevention tab
intact.
• Check the time and date are correct 21 .
Example:
Program a timer recording for 23rd day, channel 125
(Cable TV), 7:00 - 9:30 PM (Tape speed : SLP).
1
Press or to select one of the program line,
then press ENTER. 3
Press or to select the date, then press . 4
Set the start time, end time, channel and tape
speed as in step 4.
Then press ENTER. 5
To set the timer for another program, repeat
steps 3 to 5 to set another program. 6
Press both TIMER REC at the same time. The
TIMER REC indicator will light. The Timer is
programed, when the programed time is
reached, the recording is automatically
started.
To cancel timer recording, press
both the buttons again and TIMER
REC indicator will go out.
7
/ / / / ENTER/MENU
TIMER REC SET
DATE 2 3(THU)
START 7:0 0PM
END 9:3 0PM
CH 125
SPEED SLP
SETUP
MENU
TIMER
REC
TV/VCR
MENU
ENTER
ENTER
TIMER REC
Press or to select “TIMER REC SET”, then
press
.
2
ENTER
ENTER
TIMER REC SET
AUTO REPEAT
/ / / / MENU
OFF
/ / / / MENU
S P
TIMER REC SET
DATE 2 3(THU)
START 8:3 0AM
END Р Р:Р Р
CH 0 1 2
SPEED
ENTER
ENTER
TIMER REC
/ / / MENU
OFF
TIMER REC SET
AUTO REPEAT
2 3 T H 7 : 0 0 P M 9 : 3 0 P M 1 2 5 S L P
/ / ENTER/CANCEL/MENU
5L00201C [E]p38-41 20/4/04, 16:07 40