Tv/cable selection – Toshiba MW24FP1 User Manual
Page 26
26
Select the desired channel to be added or
deleted using Direct channel selection (0–9), /
or CHANNEL
/
.
Press MENU in the TV mode, then press
or
to select
option.
Press or to select “TV/CABLE”.
1
2
Press MENU repeatedly until the menu screen is
cleared.
4
Press
or
to select “TV” or “CABLE”.
3
TV - VHF/UHF channels
CABLE - Cable TV channels
Cable TV chart
The chart below is typical of many cable system channel
allocations.
TV/CABLE selection
To memorize channels
This unit is equipped with a channel memory feature which allows
channels to skip up or down to the next channel set into memory,
skipping over unwanted channels. Before selecting channels, they
must be programmed into the unit’s memory. In addition to normal
VHF and UHF channels, this unit can receive up to 113 cable TV
channels. To use this unit with an antenna, set the TV/CABLE
selection to the TV position. When shipped from the factory, this
selection is in the CABLE position.
ADD
0-9
CH 001
/
/
/
/
/ MENU
To ADD/DELETE channels
Press or to select the “AUTO CH MEMORY”,
then press
.
The TV will begin memorizing all the channels available
in your area.
Automatic memory tuning
Press or to select “ADD/DELETE”, then
press
.
1
Press
or
to select “ADD” or “DELETE”,
whichever function you want to perform.
3
2
TV/CABLE
AUTO CH MEMORY
ADD/ DELETE
/ / / / MENU
CABLE
/ / / / MENU
TV/CABLE
AUTO CH MEMORY
ADD/ DELETE
CABLE
/ / / / MENU
TV/CABLE
AUTO CH MEMORY
ADD/ DELETE
TV
/ / / MENU
TV/CABLE
AUTO CH MEMORY
ADD/ DELETE
CABLE
/ / / MENU
TV/CABLE
AUTO CH MEMORY
ADD/ DELETE
CABLE
SETUP
MENU
ENTER
ENTER
ENTER
SETUP
MENU
ENTER
ENTER
ENTER
ENTER
0
8
7
9
6
5
4
3
2
1
0–9
MENU
CHANNEL
Note:
You can not select
option if you set the channel to “LINE1”
or “LINE2”.
TV operation
CHANNEL
/
5L00201C [E]p22-26
20/4/04, 16:05
26