Basic configuration, Powering up, Setting the country – Telos Zephyr Xport User Manual

Page 15

ZEPHYR

XPORT

USER’S GUIDE

CHAPTER 2 - GETTING STARTED

Ideally, you should check an unknown line by connecting an ordinary analog telephone
and attempting a call.

HOT TIP! The Xport uses the center pins of the 6- position miniature modular jack -

In parts of Europe we have seen the same type of jack using different pins. In this case,
you will need an adaptor.

Powering Up

Time to turn on the

XPORT!

• Connect the provided IEC power cable to the

XPORT

• Connect the other end of the IEC cable to your AC (mains) power outlet.

The Zephyr Xport’s power input is universal, accepting anything from 100
to 240 Volt AC 50/60Hz.

• Flip the power switch, located just above the power cable connector, to the

“on” position (push in the side labeled “1”).

• Your Zephyr

XPORT

will start up. After about 40 to 60 seconds, the front

panel LCD display screen will be displayed:

Snd

════════

Rcv

════════

Idle

Modem Performance

Snd

════════

Rcv

════════

Basic Configuration

Setting the Country

The

XPORT

can be used on analog lines from all over the world. To achieve optimal

operation, you must tell it the country in which you are located. Follow these steps:

• Press the