Tripp Lite 700 - Manual (Page 2)

Built-in phone/Ethernet suppression jacks protect modem, fax machine or other peripheral with a dialup,DSL, or data line connection
Built-in audible alarm and 3 front panel LEDs indicate line power, battery power and battery low/replace status
700VA/425W power handling ability supports a variety of computer, internetworking, telecom and consumer electronics equipment
Supports hot-swap battery replacement via built-in access panel
Compatible with 120V/60Hz applications for USA, Canada, Mexico and more
$150,000 connected equipment insurance (USA and Canada Only)
Specifications
OUTPUT
Output Volt Amp Capacity
(VA) 700
Output Watt Capacity
(watts) 425
Nominal Output Voltage(s)
Supported 115V; 120V
Frequency compatibility 60 Hz
Output voltage regulation
(Battery mode) 115V (+/- 5%)
Built-in UPS output
receptacles 6 5-15R outlet(s)
Surge suppression only
outlets 3 UPS outlets, 3 surge-only outlets
Output AC waveform (AC
mode) Sine wave
Output AC waveform
(battery mode) PWM sine wave
INPUT
Rated input current (at
maximum load) 12A
Nominal Input Voltage(s)
Supported 120V AC
UPS input connection type 5-15P
UPS Input cord length (ft.) 6
UPS Input cord length (m) 1.8
Recommended Electrical
Service 15A 120V
BATTERY
Full load runtime (minutes) 3.9 min. (425w)
Half load runtime (minutes) 11.2 min. (215w)
DC system voltage (VDC) 12
Replacement battery
cartridge (internal UPS
battery replacement) RBC51
Battery Access Battery access door
Battery replacement
description Hot-swappable, user replaceable batteries